상품명 | 12A BL ESC for 250 FPV Racing |
---|---|
제조사 | 자체제작 |
원산지 | 국내 |
판매가 | 11,800원 |
적립금 | 120원 (1%) |
상품코드 | P00000DC |
국내·해외배송 | 국내배송 |
배송방법 | 택배 |
배송비 | 3,000원 (50,000원 이상 구매 시 무료) |
수량 |
SNS 상품홍보 | |
---|
(최소주문수량 1개 이상 / 최대주문수량 0개 이하)
[HBW] 12A BL ESC for 250 FPV Racing
하비윙 사의 미니 200~250급 레이싱 쿼드용 12A 변속기.
<Specifications>
- Output capacity : Continuous current 12A, short-time current 15A (less than 10 seconds);
- Power input : 2S~3S(7.4V~11.1V)
- BEC Output: 5V @ 1A (linear regulator mode -linear mode)
- Throttle signal frequency range (Refresh rate): 50Hz-432Hz;
- Maximum speed: 2-pole motor 210,000 rev / min, 6-pole motor 70000 rev / min, 12 pole motor 35000 rev / min;
- Dimensions: 38mm (length) * 18mm (width) * 6mm (high);
- Weight: 9g
<Main Features>
- Safe power function : power, regardless of the position of the throttle stick in any motor will not start immediately, to prevent injury;
- Throttle range calibrated features: remote control to adapt to the difference between different throttle range, improving throttle response linearity;
- programmed project (available throttle stick or LED parameter settings tab settings) :
● Brake setting: no brake / with brake;
● Battery type: Lithium Battery / NiMH;
● Low Voltage Protection Mode: Soft Shutdown / hard shutdown;
● Low Voltage Protection Threshold: low / medium / high;
● Start mode: Normal / Soft / Super-soft and starting;
● Timing: low / medium / high;
● Restore factory defaults;
- Comprehensive protection features:
● Voltage protection: programmed by the user when the battery voltage is lower than the protection threshold, ESC automatically reduces the output power;
● Overvoltage protection: the input voltage exceeds the input range allows not start, automatic protection, also issued a hasty "beep" warning tone;
● Overheat protection: Built-in temperature detection circuit automatically reduces the output power when the ESC temperature is too high;
● Remote control signal loss protection: remote control signal to reduce the power loss of 1 second, 2 seconds then there is no remote control signal disables the output;
매뉴얼을 참조해서 아래와 같이 메인 프레임 PCB에 다이렉트로 솔더링 합니다.